How to choose a good large-scale injection molding machine

Because the injection molding machine is a device that injects thermosetting plastics into molds of different shapes to realize the molding of plastic products. Large-scale injection molding machines mostly use electromagnetic heaters to achieve energy-saving effects, and in terms of power consumption and energy saving, a frequency converter is selected to change the frequency of the equipment’s operating power. This will achieve better reliability and achieve greater reliability Good performance, so we need to make better choices based on the actual situation, and the reliability will be greatly improved.

Of course, energy-saving materials for large-scale injection molding machines with good quality are realized in terms of heating and power. Therefore, it is necessary to make better choices according to the actual situation. The quality assurance achieved will also have more outstanding performance, so it can be achieved. Reliability will also be greatly improved. Choose to know that the electromagnetic heater can save heating time, directly act on the heating pipe, and the special insulation layer can improve the heating efficiency, while the heating efficiency is high, etc., which are the reasons to ensure more energy saving. In the past, resistance heating coils had low efficiency and large heat loss, so they were very electricity-consuming. Therefore, the cost of processing plastic products has been greatly increased.

We choose a good large-scale injection molding machine to achieve good energy-saving effects. We mentioned the energy-saving of the heating part above. Now we mainly talk about energy-saving in terms of power. If the equipment only needs 30HZ power during operation, and the actual power of the motor may be higher, it will cause energy waste. Then choose a frequency converter for adjustment to ensure how much equipment needs. The power output depends on how much power is output, so the energy-saving effect that can be achieved is definitely good, so the reliability achieved will be better.

Post time: Apr-12-2021